Tools to assist in making the right choices.

Hydraulic system components, diagnostic tools, Concrete Pumper Support, and more.
mDrive

m DRIVE PTO Pump Speed Calculator

Determine PTO / pump speed, calculate engine speed, hydraulic piston and gear pump specifications, pump part numbers, fitting dimensions, PTO part numbers and specifications, REPTO information, and more. How to Use the Mack PTO Pump Speed Calculator.

DOWNLOAD EXCEL

Mack Trucks

Other PTO calculations

Determine PTO output HP at required speed, PTO torque calculation, Engine Speed Requirements, Pump Bending Moment, and more.

DOWNLOAD EXCEL

Mack Trucks logo Gold-Bulldog

Mack Trucks Customer Adaptation Center Opens New Facility

The Mack Trucks Customer Adaptation Center is pleased to announce the opening of our new 20,000 square foot modification facility located at Mack Trucks Lehigh Valley Operations.

DOWNLOAD PDF

Mack Trucks

American Concrete Pumping Association

The source for Concrete Pumpers, Contractors, Manufacturers, Safety Programs, Concrete Equipment Insurance and more.

VIEW FULL SITE

Mack Trucks

Diagnostics

Mack offers excellent software tools to assist customers, service technicians and bodybuilders in performing their own diagnostic work on Mack trucks and components.

CLICK HERE TO ACCESS DIAGNOSTIC TOOLS

Mack Trucks

Concrete Pumper Support Line

Only available by Mack Trucks, Inc. Supported by dedicated Mack OneCall agents, who stay with your repair until completed, maximizing customer uptime.

DOWNLOAD PDF

Request Assistance

If you are still having trouble finding what you are looking for, Mack Service Operations has created a Body Builder Support Group. Don't hesitate to contact us directly.

CONTACT US

What is the minimum RPM I should operate my PTO, so that my vehicle will perform Regeneration during PTO mode?

Regeneration in PTO Mode - when a vehicle is being operated in PTO mode and a diesel particulate filter (DPF) regeneration is commanded, the engine must be run at a speed above the minimum speeds listed in the tables in Body Builder Manual, Section 9, Table of Contents / Regeneration in PTO Mode. The minimum speed setting can be affected by ambient temperature and/or altitude.

On Mack mDRIVE, with PTO engaged while in neutral, and then selecting Drive the PTO stops turning. Why?

Remember that the m DRIVE is an automated manual transmission with a clutch. With the PTO engaged while in neutral, when selecting Drive, the clutch is released, then the transmission shifts into gear. When the driver takes his foot off the brake pedal and presses the throttle pedal the clutch will reengage and the PTO will start to turn again. The transmission will not shift gears and driver is limited to about 6 MPH.

Transmission mounted PTO’s are primarily used for stand-still operation, with the gearbox in neutral. However it is possible to engage PTO in vehicle speeds up to 6 MPH. If the vehicle is to have a moving PTO operation, an m DRIVE with a REPTO or FEPTO is recommended.

MORE